US EPA Method 5B - Determination Of Nonsulfuric Acid Particulate Matter Emissions From Stationary Sources
NOTE: This method does not include all of the specifications (e.g., equipment and supplies) and procedures (e.g., sampling and analytical) essential to its performance. Some material is incorporated by reference from other methods in this part. Therefore, to obtain reliable results, persons using this method should have a thorough knowledge of at least the following additional test methods: Method 1, Method 2, Method 3, Method 5.Content [ show/hide ].
Nonsulfuric acid particulate matter. No CAS number assigned.
This method is determining applicable for the determination of nonsulfuric acid particulate matter from stationary sources, only where specified by an applicable subpart of the regulations or where approved by the Administrator for a particular application.
Adherence to the requirements of this method will enhance the quality of the data obtained from air pollutant sampling methods.
Particulate matter is withdrawn isokinetically from the source and collected on a glass fiber filter maintained at a temperature of 160 ± 14 C (320 ± 25 F). The collected sample is then heated in an oven at 160 C (320 F) for 6 hours to volatilize any condensed sulfuric acid that may have been collected, and the nonsulfuric acid particulate mass is determined gravimetrically.
This method may involve hazardous materials, operations, and equipment. This test method may not address all of the safety problems associated with its use. It is the responsibility of the user of this test method to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to performing this test method.
Same as Method 5, Section 6.0, with the following addition and exceptions:
The Probe liner heating system and filter heating system must be capable of maintaining a sample gas temperature of 160 ± 14 C (320 ± 25 F).
An oven is required for drying the sample.
Same as Method 5, Section 7.0.
Same as Method 5, with the exception of the following:
oven dry the filter at 160 ± 5 C (320 ± 10 F) for 2 to 3 hours, cool in a desiccator for 2 hours, and weigh. Desiccate to constant weight to obtain the initial tare weight. Use the applicable specifications and techniques of Section 8.1.3 of Method 5 for this determination.
Maintain the Probe outlet and filter temperatures at 160 ± 14 C (320 ± 25 F).
Same as Method 5, Section 9.0.
Same as Method 5, Section 10.0.
Same as Method 5, Section 11.0, except replace Section 11.2.2 with the following:
Note the level of liquid in the container, and confirm on the analysis sheet whether leakage occurred during transport. If a noticeable amount of leakage has occurred, either void the sample or use methods, subject to the approval of the Administrator, to correct the final results. Measure the liquid in this container either volumetrically to ± 1 ml or gravimetrically to ± 0.5 g. Transfer the contents to a tared 250 ml beaker, and evaporate to dryness at ambient temperature and pressure. Then oven dry the Probe and filter samples at a temperature of 160 ± 5 C (320 ± 10 F) for 6 hours. Cool in a desiccator for 2 hours, and weigh to constant weight. Report the results to the nearest 0.1 mg.
Same as in Method 5, Section 12.0.
Same as Method 5, Section 17.0.